Updated November 2026
An andrew james automatic pet feeder can handle your pet’s daily meals on a fixed timetable, so you can keep to a routine even on busy mornings. This guide walks through unboxing, placing the feeder, programming meal times and portions, and running a quick test before you rely on it. Most setups take under 30 minutes if you follow the steps in order.
Before You Start: Unbox and Place the Feeder
Check the box against the contents listed in the manual before you throw any packaging away. Look for the bowl, food hopper or lid, power adapter or battery compartment, and the separate ice pack or stopper if your model includes one. Wash the bowl and hopper with warm water and mild dish soap, then dry them fully so no residue or moisture gets into the food.
Shopping for one? See our guide: 4 Best Automatic Pet Feeder PetSafe Models Compared (2026).
Choose a flat, stable surface away from direct sun, heaters and the water bowl. Keep the feeder within reach of a power outlet if you are using the mains adapter, or make sure the battery compartment is accessible. Pets are less likely to knock over a feeder that sits on a solid floor or counter with some clearance around it.
Program Meal Times and Portions
Most andrew james models use a set of buttons and a small display to enter the clock time and each feeding slot. Set the current time first, because every scheduled meal depends on it. Then enter the number of daily meals and the time for each one, spacing them evenly across the day when possible.
Portion control is usually set by the number of units or the amount per serving, depending on the model. Start with the feeding guidelines printed on your pet food package, then adjust based on your pet’s weight and activity level. Your veterinarian can confirm the right daily amount, especially for puppies, kittens, seniors or pets with health conditions.
Quick Programming Checklist
- Set the clock to the correct time of day.
- Enter the number of meals per day.
- Set each meal time, starting with the earliest.
- Set the portion size for each meal.
- Confirm the settings on the display before you close the lid.
Test the Feeder and Monitor the First Few Days
Run a manual test dispense before you trust the schedule. Use the test or manual feed button, then check that food falls into the bowl at the expected amount. Adjust the portion setting if the output looks too small or too large for the serving you planned.
Watch your pet during the first two or three days. Some animals take a while to learn that food arrives at the feeder, and others may try to get into the hopper. If the schedule drifts or the feeder stops responding, the troubleshooting steps in the manual usually cover battery checks, lid alignment and power connections. For a deeper look at fixes, see Westlink 6l Automatic Pet Feeder Food Dispenser Manual: Setup Steps and Fixes, which covers similar dispensing mechanisms.
Common Mistakes to Avoid
- Forgetting to set the clock, which causes every meal to fire at the wrong time.
- Filling the hopper with wet or sticky food, which can clog the dispensing path.
- Skipping the test dispense and assuming the portion setting is correct.
- Placing the feeder where the pet can knock it over or reach the power cord.
- Letting the hopper run low without checking it, especially on days with a full schedule.
Recommended Gear
A stable mat under the feeder keeps the bowl from sliding on hard floors and catches stray kibble. View on Amazon
A set of replacement food-safe bowls lets you swap out a dish during cleaning so the feeder is never out of service. View on Amazon
A small set of measuring cups helps you check portions against the feeder’s settings and the food label. View on Amazon
FAQ
How long does it take to set up an andrew james automatic pet feeder?
Most owners can finish unboxing, placing and programming the feeder in under 30 minutes. Allow a few extra minutes for the first test dispense and a short check of the display.
What if the feeder dispenses the wrong amount?
Recheck the portion setting first, then run a manual test and compare the output to your target serving. Clean the hopper and bowl if food is sticking or building up near the outlet.
Should I consult my vet before setting portions?
Yes. Your veterinarian can recommend a daily amount based on your pet’s age, weight, activity and health, which is especially important for pets with medical conditions.
Conclusion
With the clock set, meal times programmed and a test dispense completed, your andrew james automatic pet feeder should keep feeding on schedule. Review the portions every few weeks, since your pet’s needs can change with age and activity. A quick check of the hopper and bowl each week will keep things running smoothly.

